Wet/Dry Vac Assembly - RIDGID RT14000 Mode D'emploi

ASSEMBLY

Wet/Dry Vac Assembly:

Accessory Caddy Installation
1. Position the Accessory Caddy on the
back of the Dust Drum and align the
Locking Tabs.
2. Slide the Accessory Caddy Tabs into
the Dust Drum and push the Locking
Tabs in until you hear a click. Pull on
the Accessory Caddy to confirm it has
locked into place.
ASSEMBLED
Locking
Tabs (2)
Accessory
Caddy
Attaching/Removing
Powerhead Assembly to
Dust Drum
1. Place Powerhead Assembly on top of
Dust Drum with the Extended Lip of
the Lid aligned with the Inlet. Be sure
Powerhead Assembly is fully seated on
the Dust Drum.
Powerhead
Assembly
Extended
Lip
Vac
Dust Drum
Inlet
Dust
Drum
2. Press in on the two Latches located
on either side of the Dust Drum until
they snap into place, securing the
Powerhead Assembly to the Dust Drum.
3. To remove the Powerhead Assembly,
pull out on the two Latches and lift
Powerhead Assembly from the Dust
Drum. Do not force the Latches to
rotate more than slightly outside Drum
flange.
Powerhead
Assembly
Drum
Latches
(1 on each
side)
Dust
Drum
8