SPM IPro Notice D'utilisation Et D'entretien page 50

"FILTER" or "CUT/OUT"
message appears on
capacitive touch panel
Board error code
E14 or E24 or E34 message
appears on the capacitive
touch panel display.
1, 2 e 3 are respectively the
left, centre and right bowls.
E15 or E25 or E35 message
appears on the capacitive
touch panel display.
1, 2 e 3 are respectively the
left, centre and right bowls.
E11 or E21 or E31 message
appears on the capacitive
touch panel display.
1, 2 e 3 are respectively the
left, centre and right bowls.
E12 or E22 or E32 message
appears on the capacitive
touch panel display.
1, 2 e 3 are respectively the
left, centre and right bowls.
E01 or E04 or E05 or E06
message appears on
capacitive touch
display.
E02 message appears on the
capacitive touch
display.
E03 message appears on the
capacitive touch
display.
Data di emissione: Dicembre, 2018
The filter is dirty and needs to be
•
the cleaned
The unit is positioned too close to a wall
•
or other object restricting air flow and
causing the machine to run at a higher
temperature
The filter is not properly installed
•
The unit has been installed near a heat
•
source, such as a coffee machine, ice
maker or cold beverage machine which
expels hot air from its vents, causing the
machine to run at a high temperature.
Possible cause
The product consistency is too high
•
An ice block is obstructing the auger
•
rotation
An ice block is blocking the auger
•
rotation
The gear motor is defective
•
The temperature
•
corresponding bowl is short circuited.
The temperature
•
corresponding bowl is disconnected.
The control board is defective
•
the
panel
The condenser temperature probe is
•
panel short circuited.
The condenser temperature probe is
•
panel disconnected.
•
•
•
•
•
•
•
•
probe of the
•
probe of the
•
•
•
•
Revisione: 1
Clean and replace filter following
instructions
Reposition unit to maximize
ventilation space (see
installation figures)
Properly install filter see
Reposition unit to maximize
ventilation space (see
installation figures)
Solution
Reduce the product consistency
Remove ice blocks
Remove ice blocks
Replace the gear motor
Check and replace the probe
Check and connect the probe
Replace the board
Check and replace the condenser
probe
Check and connect
condenser probe
Pag. : 50/80
the