SPM IPro Notice D'utilisation Et D'entretien page 45

- Reassemble the parts of the dispensing tap,
making sure that the gaskets (J) are lubricated
with Vaseline grease so that the tap slides
smoothly back into its fixed position, until it's
completely inserted (see figure 24).
!Important!
The not perfect sliding of the tap
compromises its own seal.
- Remove the drip tray and pulling it forward
(see figure 25). Wash each part thoroughly,
then reassemble the parts by inversely following
the procedures described above.
- Plug the unit back into appropriate power
supply.
- After the cleaning and reassembly as per
above instructions, fill the bowl with a mix of
water and an approved sanitizer (KAY-5
Sanitizer), according to the measures specified.
- Start the mixing part of the machine to
sanitize all the parts following the cleaning
solution specifications.
- Drain the cleaning solution as follows:
Unscrew the two knobs;
•
Then lower the bowl to drain out any
•
remaining product through the
dispensing valve.
- Screws the knobs to fix the bowls.
Data di emissione: Dicembre, 2018
®
Revisione: 1
Fig. 24
Fig. 25
Pag. : 45/80