EN
Rev.1 08/09/2021
Pag.44
Menu 01 – Chrono setting
Allows all chronothermostat functions to be enabled/disabled;
select ON to activate the function and display the relevant segment/LED
[ D ]
When Daily, Weekly or Week End programming is entered, the appropri-
ate segment/LED [ C ] appears in the top right of the display.
Regarding selections and entering times, use the buttons: the 'P3' (SET)
button allows you to enter the submenus, or if not present, to go to the
next item; the 'P5' and 'P6' buttons allow you to navigate the submenus,
the 'P1' and 'P2' buttons allow you to change the value and the 'P4' button
allows you to go back.
By accessing the submenus DAY PROGRAM, the daily chronothermostat
functions can be enabled/disabled and set.
It is possible to set two operation stages delimited by the times set ac-
cording to the following table where the setting OFF tells the clock to
ignore the command.
Selection
Meaning
START 1
activation time
STOP 1
deactivation time
START 2
activation time
STOP 2
deactivation time
By accessing the submenu WEEK PROGRAM it is possible to enable/
disable and set the weekly chronothermostat functions.
The weekly programmer has 4 independent programs whose final effect
consists of a combination of the 4 programmings.
⚠
Carry out programming making sure not to overlap the hours of activation and/or deactivation on the same day in different
programs.
By accessing the submenu WEEK-END PROGRAM it is possible to ena-
ble/disable and set the week-end (Saturday and Sunday) chronothermo-
stat functions.
⚠
Activate WEEK-END programming only after deactivating the weekly programming. To avoid unwanted startup and shutdown
operations, only activate one program at a time. Deactivate the daily program if the weekly program is required; with this
setting it is advisable to deactivate the week-end program.
Use and maintenance manual HR EVO Smart
Possible values
time - OFF
time - OFF
time - OFF
time - OFF
D
C
Input
Menu level
Input
Menu level