Menu 01 - Chrono Setting - Ravelli HR EVO 290 Manuel D'installation

Rev.1 16/03/2018
ENG
Pag.76
Menu 01 – Chrono setting
Allows all chronothermostat functions to be enabled/disabled;
select ON to activate the function and display the relevant segment/
LED [ D ]
When Daily, Weekly or Week End programming is entered, the
appropriate segment/LED [ C ] appears in the top right of the
display.
Regarding selections and entering times,
use the buttons.
By accessing the submenu: DAY PROGRAM, the daily chronothermostat functions can be enabled/disabled and set.
It is possible to set two operation stages delimited by the
times set according to the following table where the setting
OFF tells the clock to ignore the command.
Selection Meaning
START 1 activation time
STOP 1 deactivation time
START 2 activation time
STOP 2 deactivation time
By accessing the submenu: WEEK PROGRAM it is possible to
enable/disable and set the weekly chronothermostat functions.
The weekly programmer has 4 independent programs whose final
effect consists of a combination of the
4 programmings.
The weekly programmer can be activated or deactivated;
also, by setting OFF in the time field, the clock ignores the
corresponding command.
Carry out programming making sure not to overlap the hours of activation and/or deactivation on the same day
in different programs.
By accessing the submenu: WEEK-END PROGRAM it is possible
to enable/disable and set the week-end (Saturday - Sunday)
chronothermostat functions.
Activate WEEK-END programming only after deactivating the weekly programming.
To avoid unwanted startup and shutdown operations, only activate one program at a time.
Deactivate the daily program if the weekly program is required; with this setting it is advisable to deactivate the
week-end program.
HR EVO 290 - 350 - 390
Possible values
time - OFF
time - OFF
time - OFF
time - OFF
use and maintenance manual
D
Input
Input
Menu level
C
Menu level