Muller licht tint 404010 Mode D'emploi page 44

Troubleshooting
Problem
Bulb is not working.
The wrong bulb lights up.
The light switches off suddenly.
You have added a new bulb and
this bulb switches off when you
select a coloured light function.
You want to add a new bulb, but
the ones that are already added
are blinking.
The bulb has been added to the
wrong group.
I cannot add a bulb to a new
system.
Possible causes
The batteries in the tint remote control are
dead and must be replaced.
The bulb itself is switched off or the mains
plug is not plugged in.
You have selected the wrong group, or
have not selected a group, using the group
button. Select the right group or select
"All groups" by pressing the group button
repeatedly (all LEDs above the group button
will light up).
Use the group button to select the right
group or use the group button to select "All
groups".
You have selected the "Sunset" scene.
Not an error.
The new bulb can only light up in white. Not
an error.
Switch off the bulbs that are already added
or remove them from the product that has
already been connected.
Find out for sure which group the bulb is in.
Proceed as described in "Add a bulb from
one group into another group".
Please check whether the bulb is in coup-
ling mode.
tint-REMOTE CONTROL
INSTRUCTION MANUAL
44