Muller licht tint 404010 Mode D'emploi page 42

Remove a bulb from the tint remote control
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will
signal that it has been selected by increasing and decreasing its brightness.
5. Hold down the standby button for approx. 5 seconds.
The bulb will then signal that it has been removed from the tint remote
control and the procedure is finished by flashing and then dimming.
Add a bulb from one group into another group
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button. (If you
would like to add a bulb from group 2 to group 1, for example, press the group
button repeatedly until the middle LED above the group button lights up).
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will
signal that it has been selected by increasing and decreasing its brightness.
The bulb will blink in the order in which they are stored in the tint remote
control.
5. Hold down the group button again for approx. 5 seconds to store the selected
bulb in another group.
The group display for group 1 will light up.
6. Using the group button, select (if necessary) the group to which you would
like to add the bulb.
After approx. 10 seconds, the bulb will be added to the selected group and the
feedback display will stop blinking. Wait this long, not pressing any buttons
during this time.
The procedure will then end and you can use the extended group as normal.
tint-REMOTE CONTROL
INSTRUCTION MANUAL
42