Muller licht tint 404010 Mode D'emploi page 37

Screwing in the wall bracket
ATTENTION
Make sure there are no pipes or wires in the wall where you intend to drill.
Depending on the surface, the wall bracket can be attached to the wall with
screws and wall plugs if required. Screws and wall plugs are included with the
bracket.
1. Separate the two halves of the bracket.
2. Use the rear of the bracket as a stencil to mark where you will drill.
3. Drill the holes and insert the wall plugs (if needed) in the holes.
4. Screw the rear of the bracket onto the wall.
5. Place the upper part of the bracket on the screwed lower part.
The bracket can now be used.
Operation
The tint remote control is a radio remote control.
• You do not need to "aim" at the bulbs with the tint remote control to operate
them. The tint remote control will also penetrate solid materials such as
walls, doors and windows.
• The maximum range (depending on the obstacles between the tint remote
control and the bulbs) is approx. 30 metres in the open air.
• Each button press will be confirmed by the feedback display lighting up.
tint-REMOTE CONTROL
INSTRUCTION MANUAL
37