Muller licht tint 404010 Mode D'emploi page 41

Adding a new bulb
• Take note of the technical specifications when purchasing new bulbs.
We recommend tint bulbs from Müller-Licht. When using bulbs made by
other manufacturers, it is not guaranteed that all features will be supported
or will work as intended.
• If you are using a white tint bulb that only emits white light, the coloured light
features will not be available. The bulb will be switched off.
1. Unplug the lamp at the mains, remove the old bulb and screw the new tint
bulb into the socket.
2. Press the group button repeatedly until all the LEDs above the group button
light up.
3. Plug the lamp back in at the mains and set the corresponding light switch to I or ON.
The new bulb will signal that it is in coupling mode by briefly increasing and
decreasing its brightness and changing colour if applicable. If this does not
occur, switch the bulb off and on again 5 times.
4. Hold the tint remote control very close (< 5 cm) to the new bulb.
5. Hold down the group button until the bulb begins to blink.
The feedback display will first blink red evenly; then, it will begin to blink
more quickly. This means that the tint remote control has found a signal.
The new bulb will then blink 3 times and show that it has connected to the
tint remote control. Only the left LED will now light up above the group button
(= group 1).
6. If desired, you can select a different group by repeatedly pressing the group
button (middle LED = group 2 etc.).
After approx. 10 seconds, the new bulb will be added to the selected group
and the feedback display will stop blinking. Wait this long, not pressing any
buttons during this time.
The procedure will then end and you can use the extended group as normal.
tint-REMOTE CONTROL
INSTRUCTION MANUAL
41