Muller licht tint 404010 Mode D'emploi page 43

Resetting the tint remote control
A reset will only be required in exceptional cases, such as when the bulb no
longer responds to the tint remote control after removing and reinserting the
batteries.
Resetting the remote control will delete all pre-defined group settings and you
will have to connect the tint remote control and the bulbs again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object or the battery compartment cover to press the reset
button on the back of the remote control.
3. Then, proceed as described in the section "Resetting the tint bulb" and then
as described in the section "Adding a new bulb". Each bulb will then have to
be connected individually one after the other. If, for example, three bulbs
belong to one group, you must repeat the steps in "Adding a new bulb"
3 times.
Resetting the tint bulb
Resetting the tint bulb is only required in exceptional cases, such as when the
remote control has had to be reset.
1. Switch the tint bulb on and off 5 times
2. Switch the tint bulb on again. It will now begin to cycle through its colours.
The reset has occurred as desired and you can now use the tint bulb as
normal using your remote control or other Zigbee system.
Resetting the light colour
Resetting the light colour may be necessary if you have previously assigned the
lights to another function, such as the 'Night light' scene. The corresponding
control unit is inaccessible or the batteries might even be dead. You can set the
light colour to warm white very easily without completely resetting the bulb.
This function can even be used regularly if the tint remote control is not in arm's
reach at that moment.
1. Use the light switch to switch the bulb off and on again 3 times.
2. The bulb will now start in its basic setting, warm white, 100%
tint-REMOTE CONTROL
INSTRUCTION MANUAL
43