Getting Started - Kenwood KDC-105U Mode D'emploi

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: "CANCEL" \ "DEMO" \ "PRESS" \ "VOLUME" \ "KNOB"
1
Press the volume knob.
[<Y>/N] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [SETTINGS], then press the knob.
3
Turn the volume knob to select [CLOCK], then press the knob.
4
Press the volume knob to select [CLK ADJ].
5
Turn the volume knob to adjust the hour, then press the knob.
6
Turn the volume knob to adjust the minute, then press the knob.
Press 4 / ¢ to move between the hour and minute adjustment.
7
Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode
directly while in clock display screen.
5
Then, perform steps and
4
6
above to set the clock.
3
Set the initial settings
1
Press SRC to enter [STANDBY].
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [INITIAL], then press the knob.
4
Turn the volume knob to make a selection (see the table below), then press
the knob.
5
Press and hold to exit.
• To return to the previous hierarchy, press
PRESET TYPE NML: Memorizes one station for each preset button in each band (FM1/ FM2/
FM3/ AM). ; TYPE MIX: Memorizes one station for each preset button regardless of the
selected band.
KEY BEEP BEEP ON: Activates the keypress tone. ; BEEP OFF: Deactivates.
AUX SET
AUX ON: Enables AUX in source selection. ; AUX OFF: Disables. (➜ 7)
CD READ CD READ 1: Automatically distinguishes between audio file disc and music CD. ;
CD READ 2: Forces to play as a music CD. No sound can be heard if an audio file disc is
played.
SWPRE SWPRE R/ SWPRE SW: Selects whether rear speakers or a subwoofer are connected to
the line out terminals on the rear (through an external amplifier).
SPEAKER SP OFF/ SP 5/4/ SP 6 × 9/6/ SP OEM: Selects according to the speaker size (5 inches
or 4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
F/W UP
F/W xx.xx <Y>/N: Starts upgrading the firmware. ; Y/<N>: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
.
Default: XX