Basics; Getting Started; Select The Display Language And Cancel The Demonstration; Set The Clock And Date - Kenwood KDC-X704 Mode D'emploi

Basics

Remote control (RC-406)
(supplied for
Remote sensor (Do not expose to bright sunlight.)
Pull out the insulation sheet when
using for the first time.
/ /
remotely controlled with an optionally purchased remote control.
/ /
not available.
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
)
/ / : Can be
: Remote control functions are
or VOL .
to continuously increase

Getting Started

1

Select the display language and cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1 Turn the volume knob to select [ENG] (English) / [SPA] (Spanish) /
[FRE] (French), then press the knob.
[ENG] is selected for the initial setup.
Then, (except for
"PRESS" "VOLUME KNOB".
2
Press the volume knob again.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [CLOCK], then press the knob.
To adjust the clock
3 Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Set the time in the order of "Hour" "Minute".
5
Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
) the display shows: "CANCEL DEMO"
ENGLISH
5