Panic Alarm - MetaSystem HomeAlarm C12 Notice D'utilisation

SYSTEM ARMED
- The flashing red LED on the central unit indicates that the system is armed.
However, it will only be able to generate an alarm 25 sec. after being armed if there is
an intrusion.
- The red light in the C319 module (if installed), will flash to indicate that the system is
armed.
USER INSTRUCTIONS
ARMING
Press and release the remote control button to activate the alarm system. The unit will
emit two low-volume signals (BEEPS) and the red light will flash.
After 25 seconds, the system is active and ready to go into operation in the event of a
break-in.
DISARMING
Press and release the remote control button to disactivate the alarm system. The unit
will emit a single long BEEP and the red light will go out.
If the red light does not go out and the unit emits 10 beeps close together after appro-
ximately 18 seconds, it means that during your absence there has been at least one
alarm (see the section ALARM MEMORY for a full explanation).
PARTIAL ARMING
When arming, keep the button on the remote control depressed for about 2 secon-
ds: the central unit will BEEP twice in quick succession and will then beep once more
straight afterwards. The system will be armed after about 25 seconds, however those
sensors which were memorised as partialised modules will detect an intrusion but
will not generate an alarm (they remain inhibited until the alarm is armed the next time).

PANIC ALARM

Keep the remote control button pressed for approximately 6 seconds. An alarm cycle
lasting 15 seconds will be generated that, once activated, cannot be excluded so it is
necessary to wait for the end of the cycle.