MetaSystem HomeAlarm C12 Notice D'utilisation page 20

If the red LED remains on after disarming the central unit and after about 18 sec. the
central unit BEEPS 10 times, it is possible to establish which sensor has triggered an
alarm by noting the sequence of the flashing of the red LED.
The signals continue until the unit is switched on again.
If the unit has detected alarms from more than one sensor, the appropriate signals will
be given in sequence, every 3 seconds, following the chronological order of the events.
Consult the table to identify the different sequences of the red LED on the central unit
and which sensor has generated the alarm.
The phrases "channel 1, 2..." refer to the operations carried out during installation and
given in the table of the chapter 'PROTECTED AREAS'.
If no alarms have been triggered, the red LED on the central unit will go out when the
system is disarmed.
N° OF PAUSES
OF RED LED
1
2
3
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
ALARM MEMORY IDENTIFICATION
LENGTH
OF PAUSES
long
"
"
"
short
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
SENSOR THAT
GENERATED ALARM
IR sensor on the central unit
central unit immediate contacts
central unit delayed contacts
anti-tamper
channel 1
channel 2
channel 3
channel 4
channel 5
channel 6
channel 7
channel 8
channel 9
channel 10
channel 11
channel 12
channel 13
channel 14
channel 15
channel 16