MetaSystem HomeAlarm C12 Notice D'utilisation page 21

OPERATING INSTRUCTIONS
ADDITIONAL REMOTE CONTROLS
After purchasing a new remote control from the centre that supplied you with the
alarm system, carry out the following procedures to make it operative.
1) Using the remote control supplied, arm and disarm the central unit several times
(press the button consecutively 16 times, waiting a few seconds between one operation
and the next) until the central unit emits 3 consecutive BEEPS.
2) Press the button on the new transmitter within 8 seconds until the central unit con-
firms reception by emitting 3 BEEPS.
3) Repeat step 2 for each further transmitter to be memorised, including those which
were already memorised.
4) Once all the remote controls have been memorised, wait about 8 sec. for the central
unit to exit the remote control memorising mode.
From this moment onwards, only the transmitters memorised in the above phase will
be able to command the central unit.
EXCLUDING REMOTE CONTROLS
It is possible to block operation of any remote control that has been lost or stolen: in
this way the safety of your alarm system is ensured, since only you can turn it off.
To disable any lost transmitters, repeat the operation from point 1 to point 4 in the
previous section, using all the transmitters remaining.
Any transmitters that have been lost or that will not be used in this phase, will be auto-
matically inhibited.
CAUTION
Due to the normal discharge of the rechargeable batteries in the parts with battery
back up (C12-C33-C35-C43), the battery charge may be low at the time of installation.
Therefore keep the product powered for at least 24 hours before testing the back up.