Disposal - Binzel BRS LCi Mode D'emploi

BRS LCi PLC
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Note the following instructions:
 8 Putting out of operation on page EN-22.
1 Unscrew the screws and remove the cleaning unit and the collecting tray.
2 Unscrew the screws and remove the support from the base.

12 Disposal

To correctly dispose of the product, it must first be disassembled. When disposing of the system, local regulations, laws,
provisions, standards, and guidelines must be observed.
 11 Disassembly on page EN-24
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases, and cleaning agents must not contaminate the ground or enter the sewage system. These substances must be
stored, transported, and disposed of in suitable containers. Please observe the relevant local regulations and disposal
instructions in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the consumables'
manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0424.0 • 2019-04-23
12 Disposal
EN - 25