Mounting The Reamer En - Binzel BRS LCi Mode D'emploi

BRS LCi PLC
6.4 Securing the clamping prism
1 Clamping device
Fig. 8 Securing the clamping prism
1 Insert the clamping prism (2) into the clamping device (1) from above.
2 Screw in the cylinder head screw (3).
6.5 Mounting the reamer
1 Clamping device
Fig. 9 Mounting the reamer
NOTICE
• When changing the reamer, only use tools with a compatible width across flats.
Reamer seat AF 27 mm, reamer AF 17 mm.
1 Mount the reamer (2) along with the reamer seat.
2 Tighten the reamer (2) (min. 20 Nm).
BAL.0424.0 • 2019-04-23
1
2 Clamping prism
1
2 Reamer
6 Putting into operation
2
3
3 Cylinder head screw
2
3
3 Tool
EN - 15