Setting Up The Clamping Position En - Binzel BRS LCi Mode D'emploi

6 Putting into operation
6.6 Setting up the clamping position
1 Gas nozzle
Fig. 10 Setting up the clamping position
 Fig. 7 Putting into operation on page EN-13
1 Move the torch with the gas nozzle (1) vertically to the tool axis (reamer axis) over the BRS-LCi PLC (3) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly against the
clamping prism (2).
EN - 16
1
2 Clamping prism
BRS LCi PLC
2
3
3 BRS-LCi PLC cleaning station
BAL.0424.0 • 2019-04-23