Safety Information; Layout; Items Supplied - EINHELL RT-XM 305 U Mode D'emploi D'origine

Anleitung_RT_XM_305_U_SPK7:_
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety information.

1. Safety Information

Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety information and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.

2. Layout

2.1 Drag, crosscut and miter saw (Fig. 1-3)
1. Handle
2. ON/OFF switch
3. Release lever
4. Machine head
5. Saw shaft lock
6. Movable blade guard
7. Saw blade
8. Vertical clamping device
9. Roll base with limit stop
10. Holding bar for the roll base
11. Stop rail
12. Table insert with cutting depth scale
13. Latched position lever
14. Locking grip
15. Pointer
16. Scale
17. Turntable
18. Fixed saw table
19. Scale
20. Pointer
21. Horizontal clamping device
22. Locking screw
23. Chip box
24. Drag guide
25. Locking screw for drag guide
22.10.2009 15:30 Uhr Seite 21
26. Guard
27. Fastening bolt
28. Locking screw for the horizontal clamping device
29. Locking screw for the vertical clamping device
30. Locking screw for the roll base
31. Foot with rubber stopper
32. Foot
33. Extractor adapter
34. Knurled screw for cutting depth limiter
35. Stop for cutting depth limiter
2.2 Base frame (Fig. 4)
A. Feet
B. Side part
C. Intermediate strut
D. Corner bracing
E. Bottom cross strut
F. Top cross strut
3. Items supplied (Fig. 1, 5)
Drag, crosscut and miter Saw
Clamping device (8)
Roll base with limit stop (9)
2 x Holding bar for the roll base (10)
Chip box (23)
4 x Foot (A)
2 x Side part (B)
2 x Intermediate strut (C)
4 x Corner bracing (D)
2 x Bottom cross strut (E)
2 x Top cross strut (F)
4 x Nut (G)
4 x Washers (H)
28 x Nut (I)
28 x Washer (K)
28 x Screw (L)
4 x Screw (N)
Allen key (O)
Allen key (P)
4 x Screw (M)
4 x Washer (Q)
4 x Cap nut (R)
GB
21