Tanaka TCG 24ECP SL Instructions De Sécurité Et Mode D'emploi page 17

Condition
Abnormal vibration
Engine is running but blade
does not move
Movement is poor
Engine does not stop
Engine stops when throttle
is closed
Blade continues rotating
when throttle is closed
Cause
Cutting attachment is not properly
installed
Handle, handle bracket or other
fastening part is loose
Grass is wrapped round gear case Remove grass
Grass is wrapped round gear case Remove grass and dirt
Stop switch failure
Idle speed is too low
Idle speed is too high
Throttle wire is too taut
Remedy
See "Installation of cutting attachment"
Check and tighten
Set the choke lever to START position
to stop the engine
Cease use immediately and contact
Tanaka dealer
Contact Tanaka dealer
Contact Tanaka dealer
English
17