Siemens SCALANCE X-300 Manuel De Configuration page 393

● C-PLUG removed at runtime.
● C-PLUG plugged in at runtime.
● RMON rising alarm occurred.
● RMON falling alarm occurred.
● Ring redundancy enabled.
● Ring redundancy disabled.
● (R)STP protocol enabled.
● (R)STP protocol disabled.
● Disabled (R)STP because ring redundancy is enabled.
● DIP settings taken from C-PLUG.
RM=<ON|OFF>, STBY=<ON|OFF>, R1=<ON|OFF>, R2=<ON|OFF>
● (R)STP topology change detected while (R)STP is off. Aging time will be reduced to <Zeit
in s> sec for at least <Zeit in s> sec.
● Set aging time back to original value <Zeit in s> sec.
● No connection to SNTP server. Server IP address <adresse IP>.
● Connected to SNTP server. Server IP address <adresse IP>.
● Enabled link status monitoring on ring ports.
● Changed port VLAN ID of the ring ports to 1.
● Disabled GVRP because ring redundancy is enabled.
● Disabled GMRP because ring redundancy is enabled.
● Disabled mirroring because monitor port is ring port.
● (Re)enabled ring ports (because disabled by user).
● Disabled port lock on ring ports.
● Warning: ring ports have different static VLAN configuration.
● Warning: ring ports have different VLAN port configuration.
● Warning: ring ports have different static multicast configuration.
● Warning: ring ports have different load limits configuration.
● Enter fault state: port <numéro de port> enabled for link status monitoring and link down.
● Leave fault state: port <numéro de port> disabled for link status monitoring.
● Enter fault state: power line <ID de l'alimentation> enabled for power monitoring and
power down.
● Leave fault state: power line <ID de l'alimentation> disabled for power monitoring.
● <CLI | WBM | SSH>: Authentication failure.
● Warning: OSPF consumed too much memory and is shut down.
● Duplicate IP address <adresse IP> sent from <adresse MAC>
● IN <numéro de l'entrée TOR> (<nom de l'entrée>) <high | low>
SCALANCE X-300 / X-400
Manuel de configuration, 06/2015, C79000-G8977-C187-25
D.1 Messages d'erreur du SCALANCE X300 / X400
Annexe D
393