Servicing Of Double-Insulated Appliances; Important Warnings - Nilfisk Advance Adgility 6XP Mode D'emploi

(Only for double-insulated, cord-connected appliances):
SERVICING OF DOUBLE-INSULATED
APPLIANCES
A double insulated appliance is marked with one of the
following: The words "DOUBLE INSULATION" or "DOUBLE
INSULATED" or the double insulation symbol (square within a
square).
In a double-insulated appliance, two systems of insulation
are provided instead of grounding. No grounding means is
provided on a double-insulated appliance, nor should a means
for grounding be added to the appliance. Servicing a double-
insulated appliance requires extreme care and knowledge of
the system, and should be done by qualified service personnel.
Replacement parts for a double-insulated appliance must be
identical to the parts they replace.
WARNING!
Only motorized nozzle is double insulated. To reduce risk
of electrick shock - connect vacuum cleaner to a properly
grounded outlet.
MAINTENANCE
Always keep the vacuum cleaner in a dry place. The cleaner
is designed for continuous heavy work. Depending on the
number of running hours – the dust filters should be replaced.
The dust bag must be replaced at the same time the Main
filter (sack filter) is replaced/cleaned. Keep the container clean
with a dry cloth, and a small amount of spray polish. Any
other servicing should be performed by an authorized
service representative.
Do not use with damaged cord or plug. If appliance is not
working as it should, has been dropped, damaged, left
outdoors or dropped into water, return it to a service center.
While the machine is in use do not pull or carry by the
cord, use cord as a handle, close a door on cord, or pull
cord around sharp edges or corners. Keep cord away
from heated surfaces.
The size and quality of the dust bag and fi lters affect the
machine effi ciency. Use of non original dust bags or non
original fi lters can cause restricted air fl ow which may lead to
machine overload.
This machine is equipped with a thermal cut-out to protect
the motor and other vital machine parts from overheating.
Should the machine cut out, you will have to wait at least 5-
10 minutes for it to automatically reset. While you are waiting,
switch the machine off and unplug it, then check the hose,
dust bag and filters to be sure that nothing is blocking the flow
of air through the machine.
When cleaning is performed roll up the extension cord
starting at the machine end and store it at the machine
belt by snapping the nylon tie around the cord.

IMPORTANT WARNINGS

1. This machine is also suitable for commercial use, for
example in hotels, schools, hospitals, factories, shops and
offices and for normal housekeeping purposes.
2. This machine is not suitable for picking up health
endangering dust, unless all special authorised
local/state federal precautions are complied with.
3. This machine is for dry use only and shall not be
used or stored outdoors in wet conditions. Store indoors
between max. 60°C (degrees centigrade) and min. 0°C
(degrees centigrade) 140°Fahren heit / 32°Fahrenheit..
4. The machine must not be used for the suction of water
or other liquids.
5. Live conductors must not be vacuum cleaned by the
machine for dry dust before their current has been
switched off. This is to avoid creating a shortcircuit
through the dust remaining in the nozzles and tubes.
6. The machine must not be used for picking up combustible
or explosive materials, nor should it be used in an
explosive atmosphere.
7. Under no circumstances should the machine be used for
picking up hot material. In particular the machine must not
be used for cleaning open and closed fireplaces, ovens
or similar objects that contain warm or glowing ashes.
8. The machine must not be used if the electrical cord or
plug shows any sign of damage. Regularly inspect the
cord and plug for damage, in particular if it has been
crushed, shut in a door or run over.
9. The machine must not be used if it is faulty.
10. Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
11. Always turn off this vacuum cleaner before connecting or
disconnecting motorized nozzle.
12. When repairing or replacing the cord, the same type of
cord as originally supplied with the machine must be
used. This cord can be supplied by the manufacturer.
12b.If the fixed supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
13. The plug must always be removed from the socket outlet
before starting any maintenance of the machine or the
cord.
14. Disconnect vacuum cleaner before servicing and when not
in use. Do not leave unattended vacuum cleaner
plugged in.
15. No changes or modifications to the mechanical or
electrical safety devices should be made.
INSTRUCTIONS FOR USE
Before using the vacuum cleaner make sure that the voltage
shown on the rating plate on the vacuum cleaner corresponds
with the main voltage.
Accessories shown in the illustrations may vary from model to
model.
15