Siemens TE 502 Série Mode D'emploi page 37

3� Remove the frothing tube (6c).
6c
4� Clean the individual parts with a detergent
solution and a soft brush� If necessary,
soak in a warm detergent solution�
Clean the air hole (6e) thoroughly�
5� Rinse all parts with clean water and dry.
6� Fit the steam nozzle (6d) and frothing
tube (6c) back into the metal sleeve�
6c
1
7� Twist the steam nozzle clockwise until
the marks are aligned�
8� Attach the milk frother to the steam
valve� Check that the red mark on the
steam valve is covered�
Risk of scalding
A
Only use the appliance when the milk
frother (6) is completely assembled and
fitted.
Cleaning the brewing unit
Clean the brewing unit regularly�
To pre-clean the brewing unit automatically:
1� Select
2� Place an empty glass under outlet (7)�
6e
3� Press the start button (10)�
The appliance rinses�
In addition to the automatic cleaning
programme, the brewing unit (5a) should be
removed regularly for cleaning� (See figure
E at the start of the operating instructions�)
1� Switch the appliance off at the power
on/off switch O / I (9)� No buttons are lit�
2� Open the door (5b) to the brewing unit�
3� Slide the red lock (5d) on the brewing
unit (5a) completely to the left�
6d
4� Press the eject lever (5c) down fully�
The brewing unit is released�
5� Grasp the brewing unit (5a) by the
2
recessed grips and remove carefully�
6� Remove the cover (5e) of the brewing
unit and rinse the brewing unit (5a)
thoroughly under running water�
e
by turning the rotary knob (14)�
en
33