Remove Shipping Strap - Whirlpool WETLV27FW Instructions Pour L'installation

Remove Shipping Strap (27" models)
To avoid fl oor damage, set washer/dryer onto cardboard before
moving across fl oor. Move washer/dryer close to its fi nal location.
1.
Remove strap, hang tag, and pin
Do not cut yellow strap. Pull yellow strap fi rmly until completely
removed from washer/dryer. There should be 2 cotter pins on
the end of the shipping strap. Remove the hang tag and pin
from the vent pipe.
2.
Check rear leveling legs
Tilt the washer/dryer forward. Move each of the 2 rear legs in
an up-down motion to check the self-adjusting leveling legs
for free movement. This is required for proper leveling. Gently
lower the washer/dryer to the fl oor.
12
3.
Cut shipping strap
Cut the shipping strap about 16" (406 mm) from the plug end.
Look for the words "CUT HERE." Discard end with cotter pins.
You will use the remaining piece of shipping strap to secure
the drain hose.