Lubricating The Bar Tip Sprocket; Battery Connectors - Husqvarna 436 Li Manuel D'utilisation

Masquer les pouces Voir aussi pour 436 Li:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Power trigger lockout
Make sure that the power trigger is locked at the idle
setting when the power trigger lockout is released.
Press the power trigger lockout and make sure it
returns to its original position when released.
Check that the power trigger and power trigger lockout
move freely and that the return springs work properly.
Activate the chain saw and apply full power. Release
the power trigger and check that the saw chain stops
and remains stationary.
Chain catcher
Li-ion
Li-ion
Check that the chain catcher is not damaged and is
firmly attached to the body of the chain saw.
36 – English
MAINTENANCE
Keypad
Activate the chain saw (green LED on) and make sure
the chain saw deactivates when the start/stop button
is pressed (green LED off).

Lubricating the bar tip sprocket

Lubricate the bar tip sprocket each time you refill with
saw chain oil. Use the special grease gun and a good
quality bearing grease.

Battery connectors

Clean the battery and the machines battery compartment
with a soft brush after use. Make sure all cooling slots and
battery connectors are cleaned.
Li-ion
Li-ion

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

536 lixp

Table des Matières