Publicité
Dear customer,
thank you for purchasing this product. We would like to ask you to read the following notes and tips so that you can enjoy this product
for a long time.
checking the product:
check your Shower-Set prior to installation for transport damage or other damage that may have occurred. After the installation of the
product no claims for damages will be accepted under the warranty.
Chrome surfaces have certain manufacturing characteristics. These may be hairline scratches or irregularities in the metal. There should
be no cause for concern if you cannot see any such imperfections when standing at a distance of 1,5 metres from the object and under
normal lighting conditions. The overall impressions is conclusive.
Technical Construction Requirements
Scope of use:
This product is intended for connection to a pressurized hot water supply.
When used in conjuction with water heaters from 24kW
The product is not suitable for use with non-pressurized storage (open water systems).
Large pressure differences between hot and cold water can cause problems.
Technical data:
min. flow pressure:
1 bar
max. operating pressure:
5 bar
Operating pressure greater than 5 bar = pressure reducer required
max. flow temperature:
rec. flow temperature :
Flow rate at 3 bar pressure at hand / and shower head (standard version): 9 l/min.
The valve must be drained separately in case of frost. Emptying of water pipe network is not sufficient.
Mounting
Flush before and rinse after installation according to DIN 1988 (run at main tap about 3 min. open water)
Connection to wall plates with G1/2, hole centres 150mm, hot water left, cold water right.
CARE INSTRUCTIONS
The different surfaces of today's faucetes require a meticulous care and cleaning regime.
The following rules apply:
The nozzle on the hand and/or head
shower need to be cleaned regularly in
order to prevent the build-up
of lime-scale on the nozzles.
By sweeping the back
of your hand or your
thumb over the nozzle.
Damage caused by
inadequate or improper
cleaning are not covered by
the warranty conditions.
80°C
60°C
Regular cleaning prevents the build-up of limescale!
Use a purpose recommended cleaner.
Caution: Any cleaner containing acetic acid, hydrochloric acid, chlorine
bleach or formic acid can cause considerable damage!
Adhere to the respective manufacturers instructions for cleaning.
Rinse with cold water after each period of cleaning.
No abrasive cleaning agents (scouring pads, etc.)
Do not spray the cleaning agent directly on the product, but
apply with a cloth (this prevents the accumulations of detergent)
No high-temperature cleaning agents (steam cleaners)
Do not use or store chemical cleaners near the fittings. The
release of chemicals can damage the fittings.
Damaged surfaces facilitate the penetration and infiltration of
detergents under the chrome plating which will enhance the damage.
- 3 -
Publicité
