F - Trouble Shooting Guide; G - Installation Instructions - P&C SOPS76PS Mode D'emploi

F - Trouble Shooting Guide

Symptom
No power supplied to appliance
Oven power is on but appliance does not
operate
Oven power is on but there is no heat
Display is flashing, is only part
illuminated or is cycling through various
displays.
G - Installation Instruction
INFORMATION FOR THE INSTALLER
THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN.
WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE
TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS.
DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN.
WARNING:
Installation must comply with Standards North America (within North America) wiring rules, as
well as your local electrical and building codes and regulations and any other applicable
requirements. Your appliance must be properly installed and grounded by a qualified and
licensed technician.
Incorrect installation of the appliance, resulting from not following the detailed installation
specifications, can affect the appliance performance. Ovens incorrectly installed may void the
warranty and we strongly recommend that the oven cavity and venting be prepared as described,
in the following specifications. This is critical to appearance, oven performance and safety.
Remedy
Has the power been disconnected? Check the breaker
panel. Has the main fuse or circuit breaker blown or
tripped?
Oven may be set on AUTO (see auto programmed
cooking)
Oven may be set on AUTO
Oven temperature may be set OFF
Mode may be on incorrect selection
Turn power supply to appliance off, wait 30 seconds and
turn power on. Reset clock
30