Removing The Oven Door - P&C SOPS76PS Mode D'emploi

Removing the oven door

The oven door can be easily removed for better access while cleaning. To remove the oven door:
1. Open the door fully and fit the supplied pin in the holes in the hinges on each side.
2. Raise the door slightly, holding the sides of the door about half way up. Make sure the
pin stays in the hole the entire time. Lift the door gently. This should disconnect the
hinges from the oven frame.
3. Remove the door by continuing to raise it while pulling the door away from the oven.
When handling the door be careful not to dislodge the pin from the hole. If the pin does
dislodge, the hinge will have to be closed by hand and the pin re-fitted onto the hole
before re-fitting into the oven.
To re-fit the oven door:
1. Holding the door at an angle to the oven, slide the hinges into the oven frame, making
sure that on each side the top curved arm fits into the top slot and the lower arm fits into
the bottom slot.
2. Make sure the hinges are pushed as far as they will go and the lower arm engages into
the plate mounted in the oven frame.
3. Open the door fully and ensure the pin fully disengages from the hole. The door can now
be opened as normal.
Changing the light bulb
WARNING:
Ensure that the appliance is switched off before replacing the lamp to avoid the possibility
of electric shock
The light bulb is located behind the glass cover and is a push-in design.
To change the light bulb:
1- Gently remove the outer glass cover.
2- Pull the light bulb up and out of the housing. Push in the
replacement bulb.
3- Replace the glass cover making sure it fits correctly into place.
NOTE:Recommended bulb: Halogen 40W / 240V
29