Changing The Tool; Starting Operation - Bosch GO Professional Notice Originale

If you are not planning to use the power tool again soon, disconnect it from the power
supply.
The power tool cannot be used during the charging process. It is not defective if it does
not work during the charging process.
Follow the instructions on correct disposal.

Changing the Tool

Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Inserting the application tool
Push the application tool into the internal hexagon of the tool holder (2) until you hear it
engage.
Removing the application tool
Pull the application tool off the tool holder (2), using pliers if necessary.
Operation

Starting Operation

Setting the rotational direction (see figure B)
Do not use the rotational direction switch (5) when the power tool is in opera-
u
tion, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch (5) for-
wards.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction
switch (5) backwards.
Locking the spindle (see figure C)
To lock the spindle in place, slide the rotational direction switch (5) into the middle posi-
tion.
This allows screws to be driven in even when the battery is discharged and enables the
power tool to be used as a screwdriver.
Preselecting the torque
The torque presetting ring (3) can be used to preselect the required torque in six stages.
Once the set torque has been reached, the application tool will be stopped.
Stage 1:
Lower torque for driving in screws with a small diameter or for use with soft materials.
Bosch Power Tools
English | 25
1 609 92A 56G | (10.09.2019)