Installation; Operation; Before Use - pullman Ermator S 36 Propane Manuel D'utilisation

WARNING: Never use a product that is
faulty. Carry out the safety checks,
maintenance and service instructions
described in this manual. Some
maintenance and service measures must be
carried out by trained and qualified
specialists. See instructions in section
MAINTENANCE on page 9 .
WARNING: Always use genuine
accessories.
General
When unpacking the product, check that the following
accessories are included:
• The hose with end fittings
• Steel tube
• Floor Nozzle
If any of the above-mentioned parts are missing, please
contact your local distributor or our sales representative.
Introduction
Dust-laden air is sucked through the inlet valve at high
speed via the suction hose. The cyclone slows down the
air and separates coarse dust particles through
centrifugal force and gravity. The double filter system
then separates the air and finer particles. The dust
extractor is designed for filter cleaning by reverse air
pulse.
The separated dust accumulates in the cyclone until the
product is switched off, when it drops through the bottom
flap into the plastic bag. The filter cleaning process is
not completed before it is clear that the dust inside the
tank has fallen into the collection bag. In some extreme
cases the adhesive ability of the dust must be broken
down manually. This can be done by hitting the dust
through the bag or tapping the pre-filter housing.

Before use

Before use, the operator must be trained in the handling
of the dust extractor and the hazardous dust.
WARNING: Before starting the engine,
check the service table for daily
maintenance.
WARNING: While the engine is running, the
exhaust contains chemicals such as
unburned hydrocarbons and carbon
570 - 003 - 07.06.2018

INSTALLATION

For models that do not already have the front casters
assembled due to packaging limitations:
• Assemble the front casters using the bolt or nut and
washer included in the package depending on your
application.
Please dispose of packaging materials and used product
components in an environmentally safe way according
to local disposal regulations. Always remember to
recycle.

OPERATION

To connect the battery
• Make sure that the wires are firmly connected to the
correct terminals, red (+) first, black (-) second.
Disconnect the battery in reverse order.
• Make sure that the bracket that holds the battery in
place is correctly assembled, so that the battery
can't move during operation.
To connect the propane tank
1. Make sure that the tank is firmly held in place by the
locks and holder plate. It should not be able to move
when correctly assembled.
WARNING: Make sure the assembly area is
firm, so the dust extractor does not tip over.
Risk of personal and material injury.
WARNING: Risk of pinching when handling
the toggle fasteners.
CAUTION: When the LPG tank is attached
to the machine and not running, the tank
valve must be in the CLOSED position.
monoxide. Exhaust fumes are known to
cause respiratory problems, cancer, birth
defects or other reproductive harm. Carbon
monoxide is colorless and tasteless and is
always present in exhaust fumes. The onset
of carbon monoxide poisoning is
distinguished by a slight dizziness which
may not be recognized by the victim. A
person may collapse and lapse into
unconsciousness with no warning if the
concentration of carbon monoxide is
sufficiently high. Since carbon monoxide is
colorless and odorless, its presence cannot
be detected. Any time exhaust odors are
noticed, carbon monoxide is present.
7