Mains Connection; Machine Operation; Maintenance And Inspection; Cleaning Filter - Jet DC-1200-M Mode D'emploi

Attention:
Hoses and ductwork, must be ground connected (PE) , to
avoid electro‐static charging, which could cause ignition‐
sparks.
(JET Dust Collection Grounding Kit, Article Number: JW1053).
5.4 Mains connection
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a 16 A surge‐proof fuse.
Only use power cords marked H07RN‐F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
6. Machine operation
You can start and stop the machine with the magnetic switch
(R, Fig 13).
Attention:
(400V version) if the direction of rotation is not correct, the
phase converter inside the CEE Euro plug (T) must be pushed
in and turned 180°.
(See rotation arrow on machine for correct rotation)
Fig 12
Fig 13
7. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be carried
out after the machine is protected against accidental starting
by pulling the mains plug.
Inspect the proper function of the dust collection system
daily.
Clean the unit regularly.
Defective safety devices must be replaced immediately.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
7.1 Cleaning Filter
The filter must be cleaned when the air flow reduces, and
before changing the collecting bag.
Shake the filter bag whenever it is clogged and before each
collector bag change.
During the cleaning of the filter bag it's necessary to use a
mask (mask with filtration).
7.2 Changing collector bag
Always disconnect the dust collector from the power source
(unplug) before servicing or changing filter.
During the changing or cleaning of the collector bag it's
necessary to use a mask (mask with filtration).
8. Trouble shooting
Unit doesn't start
*No electricity‐
check mains and fuse.
*Defective switch, motor or cord‐
consult an electrician.
Air flow too weak
*Clogged filter‐
clean filter.
*Collection bag is full‐
change the bag.
*Wrong motor rotating direction (400V version)‐
change direction (see chapter 6).
9. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
This symbol indicates separate collection for electrical and
electronic equipment required under the WEEE Directive
(Directive 2012/19/EC) and is effective only within the
European Union.