Assembly - Jet DC-1200-M Mode D'emploi

For mobility, the unit is equipped with 4 wheels.
You must observe the machine´s centre of gravity, otherwise
the machine may tip!
5.2 Assembly
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the unit!
Dispose of the packing in an environmentally friendly manner.
Attention:
The dust collector must be disconnected from the power
source during assembly.
Base:
Install four casters (J, Fig 3) to the underside of the base (D)
with bolts, nuts and washers.
Motor and fan assembly:
Attach the motor base (L, Fig 4) and the motor and fan
assembly (S, B) to the base (D), using screws and washers
provided (see Fig 4).
Outlet connector assembly:
Install the gasket (I, Fig 5) and mount the outlet connector (W,
Fig 6) to the collector body (B) with screws and washers
provided (Fig 5 & Fig 6).
Fig 3
Fig 4
Collector Housing:
Attach 3 support rods (F, Fig 7) to the base using 6 hex cap
screws and washers.
Install the housing (C, Fig 8) with 6 hex cap screws.
Attach the filter bag hanger (E)...see Fig 8.
Fig 5
Fig 6
Fig 7