Dust Collection; Mains Connection; Machine Operation; Maintenance And Inspection - Jet DC-950A Mode D'emploi

Fig 4
Base:
Mount support cylinder (L, Fig 4) to
base (M) with four bolts and washers
(N).
Fig 5
Turn the dust collector over.
Collector bag:
Fold the plastic bag over the top of the
snap ring (E, Fig 6).
Fig 6
Insert the snap ring (E) of the collector
bag into the bottom of the housing at
an angle. Pull down until it engages in
the grove (F, Fig 7)
Fig 7
Filter bag:
Attach the bag support rods (B, Fig 8)
with M6 nut, spring washer and
washer (A).
Fig 8
Install the filter bag with retainer strap
(C, Fig 9).
5
Fig 9
5.2 Dust connection
The hose or ductwork you use to
connect the tool to the dust collector
must be grounded for avoiding
explosion.
(JET Dust Collector Grounding Kit,
Article Number: JW1053).

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16 A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.

6. Machine operation

You can start and stop the machine
on the main switch.

7. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.