Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TOOLS FOR INSTALLATION
Gather the following tools before beginning your installation:
•
Level
•
Screw driver
•
Impact drill
•
Drill bits
•
Pipe expander
•
Torque wrench
•
Open-end wrench
NOTE:
•
Always contact a local, qualified professional for installation.
•
Never use an underrated electrical cord or outlet!
CHOOSING INSTALLATION LOCATION
BASIC REQUIREMENTS:
Installing the unit in the following places may cause malfunction. If installation in one of
these conditions is unavoidable, please consult the local dealer:
1. Avoid placement near heat sources, as well as sources of flammable or volatile
vapors, liquids, or gas in the air.
2. Avoid placement near high-frequency devices, such as welding equipment, serv-
ers and networking equipment, & medical equipment.
3. Avoid placement near beaches or coastal areas.
4. Never place the unit in locations with oil or fumes.
5. Never place the unit near sulfur gas.
6. Avoid placement in restricted zones except under special circumstances.
7. Never place the unit in the laundry.
8. Never place the unit indoors; it is not designed for indoor use.
OTHER CONSIDERATIONS:
1. Select a location with no obstructions near the air inlet and outlets.
2. Select a location where condensation can be dispersed without impacting the
building or others.
3. Select a location near the outdoor unit, with a nearby rated power outlet.
4. Select a location that is out of the reach of children.
•
Pipe cutter
•
Leakage detector
•
Vacuum pump
•
Pressure meter
•
Universal meter
•
Inner hexagon spanner
•
Measuring tape
–10–
Publicité
Table des Matières
