Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Pass the electrical connection wires through the cable cross-hole and pull out via
the front side.
3. Remove the wire clip; connect the electrical wire to the wiring terminal according
to the color. Tighten the screw and fasten the electrical wire with the wire clip.
Wiring cover
NOTE:
•
After tightening the screw, tug slightly on the electrical cord to ensure that it is
properly fastened.
•
Never shorten or extend the electrical wire length by cutting it or adding extensions.
4. Replace the wiring cover and insert the screw.
5. Close the panel after tightening the wiring cover screw.
IMPORTANT ELECTRICAL WIRING INFORMATION
•
All wires of the indoor and outdoor unit must be connected by a qualified electrician.
•
If the length of the electrical cord is unsuitable (too long or too short), contact
your dealer for replacement solutions. Never try to extend or shorten the wire
by yourself.
•
Always ensure that the electrical outlet is easily accessible after installation.
•
If you prefer an installation without an electrical outlet, you must install a dedi-
cated circuit breaker for the unit. The circuit must be all-pole parting; the contact
parting distance must be greater than 3mm.
N(1) 2
3
Outdoor unit connector
–16–
Handle
For some 115v units
N
N(1) 2
3 L
L
N
Indoor unit
Power
connection
Wire hole
For some 115v units
OUTDOOR UNIT
G L N
N(1) 2
3
power
L
N
cord
power
connection
cord
N(1) 2
3
INDOOR UNIT
Publicité
Table des Matières
