Protecting The Environment - Würth Master MSF 30 Notice D'utilisation

Electronic overload protection
In case of a brief, very high overload on the product,
the integrated electronic overload protection will
limit the current consumption and in this way prevent
excessive heating of the motor.
If, when working with the product, the speed drops
significantly or the diamond cutting discs stop due to
an overload, leave the machine to run for a short time
at no-load.
In case of an extended overload, the light emitting
diode 6 will illuminate. Leave the product to run at no-
load until the motor has cooled to its normal operating
temperature and the light emitting diode 6 goes out.
Restart protection
If the plug is connected to the mains with the product
switched on or the supply of power is re-established
after a power failure, the product will not start. The
light emitting diode 6 flashes and the product must be
switched off and on.
Maintenance and care
Unplug from the mains before all work on the
product.
Always keep product and ventilation slots
clean.
To prevent dust building up inside the product, the
motor must be blown out after extended use of the
product (through the ventilation slots on the rear end of
the motor housing). This task should not be undertaken
indoors if possible.
Should, despite careful manufacturing procedures and
test procedures, the product fail at some point, have
the product repaired by an authorised customer service
centre for WÜRTH electrical tools.
It is imperative you state the article number (see type
plate) of the product with all queries and orders for
spare parts..
Spare parts
It is only allowed to use original spare parts. The use of
other parts can cause damage to the product.
We reserve the right to make changes without notice

Protecting the environment

Recycling instead of refuse disposal.
Products, accessories and packaging
that are no longer useable should be
sent for recycling.
Only in EU countries:
Do not throw electrical tools in household waste. In
accordance with European directive 2002/96/EC
on waste electrical and electronic equipment and its
implementation in national law, used electrical tools
must be collected separately and recycled.
Warranty
For this WÜRTH product we provide a warranty as per
legal / national stipulations from the date of purchase
(proof of purchase with invoice or delivery note).
Resulting damage will be rectified by replacement or
repair. Damage due to improper handling is excluded
from the warranty.
Complaints can only be accepted if the product is
returned, without dismantling, to a WÜRTH subsidiary,
your WÜRTH sales representative or a service centre
for electrical tools authorised by WÜRTH.
Declaration of conformity
We declare with sole responsibility that this product
complies with the following standards or standardisation
documents: EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3 in accordance with EMC directive
89/336/EEC and EN 50144-1, EN 50144-2-3
(partially) in accordance with Machinery directive
98/37/EC.
07
Adolf Würth GmbH & Co. KG
13