Product Features - Würth Master MSF 30 Notice D'utilisation

Product features

Prior to using this product, the user must become familiar
with all features and safety instructions.
Overview Fig. I
1 Scale
2 Auxiliary handle
3 Hex socket head screw
4 Star-shaped knob
5 Extraction feature
6 Light emitting diode
7 Hex socket head screw
8 Triangular marking
9 Guard
10 Guide shoe
11 Clamping nut
12 Locking knob
13 Slider switch
14 Hex bolt
15 Collar
16 Spacer rings
Product specifications
Art.
Cutting discs - Ø
Cutting disc bore - Ø
Possible channel widths
Cutting depth
Rated power consumption
Output power
No-load speed
Speed at rated load
Typical effective acceleration in the
hand-arm area *
A-weighted sound pressure level *
A-weighted sound power level *
Weight
*) Values determined in accordance with EN 60745
Correct use
The product is only intended for cutting or making slots
in predominantly mineral-based materials (without the
use of water), e.g. steel reinforced concrete, masonry
and road surfaces.
The user is liable for damage caused by incorrect use.
If you have any queries on the product and its use, in
Germany our product and application consultancy
service will be pleased to be of assistance, tel.:0180-
60 65 69 (14 cent/min).
Prior to placing the product in operation, check
whether the mains voltage and mains frequency
stated on the type plate match your mains data.
Mains connection
The product has electronic starting current limiting.
It is sufficient if the sockets to which the product is
connected are protected with a type H circuit breaker
or a fast-blow fuse.
Preparing product for fitting the diamond
cutting discs (Fig. I)
· Switch off product and isolate from the power
supply.
· Unscrew hex socket head bolt 3.
· Slightly undo hex socket head bolt 7.
· Position guard 9 and the guide shoe 10 such that
you have clear access to the drive shaft on the
product for fastening the diamond cutting discs
(Fig. II).
0702 414 X
Fitting two diamond cutting discs (for cutting a
125 mm
channel, Fig. III)
22.2 mm
· Fit collar 15 in the correct position on the drive
shaft (shoulder to the outside) and turn until it is
10, 17, 23,
locked.
30 mm
· Fit first diamond cutting disc to the collar 15. During
0 - 30 mm
this process it is imperative you pay attention to
1400 W
the direction of rotation information on the
diamond cutting disc and the product!
750 W
· Fit to the clamping nut 11, the second diamond
8200 rpm
cutting disc and the spacers to suit the width of
8200 rpm
the channel. During this process it is imperative
4 m/s² you pay attention to the direction of rotation
information on the diamond cutting disc and the
product!
92 dBA
· Fit clamping nut 11 with the diamond cutting disc
103 dBA
and the spacers to the drive shaft on the product.
3.9 kg
During this process tighten the clamping nut 11 by
turning it clockwise.
· Press in locking knob 12
· Slowly rotate front diamond cutting disc until the
locking knob 12 engages.
· Tighten the clamping nut 11 using the flange
spanner supplied.
Placing in operation
Never press in locking knob 12 with the
product running; also not when the
product is running down!
11