Cleaner Components - Pentair BLUEFURY LITE Guide D'installation

Masquer les pouces Voir aussi pour BLUEFURY LITE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38

Cleaner Components

1. BLUEFURY LITE Cleaner Head
2. Debris Bag
3. Sweep Hose
4. Feed Hose Assembly (Not shown)
• 2-10 ft. [3 m.] sections
• 1-7.5 ft. [2.3 m.] section
• 1-2.5 ft. [0.8 m.] section
5. Backup Valve (Not shown)
6. Wall Fitting
7. Wall Adapter
8. Debris Seal
Note: The cleaner system is delivered with
debris seal installed inside of cleaner head.
9. Flow Gauge
Overview
The BLUEFURY
LITE Pressure Side Pool Cleaner travels in a random pattern throughout the pool, vacuuming and sweeping
®
the bottom. The climbing ability of the BLUEFURY LITE is dependent on the pools shape. It will climb better in pools without
sharp angles or curves in theflo transition from the pool floor to the pool wall.
Approximately every 3-1/2 minutes the cleaner will go into back up mode. At this time the Backup Valve will pull the cleaner
away from its last location, allowing the cleaner to bypass any obstruction and help randomize the pool coverage.
Note: Before you install and operate your cleaner, read
through these important guidelines:
1. Always disconnect the cleaner from the pool wall when
cleaning or back washing the pool filter.
2. Dirt in the plumbing will clog the cleaner. After cleaning
or back washing the filter, let the filtration system run
for at least five minutes before reconnecting the cleaner.
3. New plumbing lines should be flushed out before
installing the cleaner.
4. The cleaner should not be used to remove plaster dust
in new pools.
5. Always remove the cleaner before swimmers enter the
pool.
6. Always handle the cleaner with care.
7. Always pick up the cleaner by the handle, especially
when lifting the unit out of the water.
8. Do not handle the cleaner while it is operating.
371885 (REV 12/2016)
CLEANER OVERVIEW
7
6
9
3
9. Always remove the cleaner from the pool before
chemical shock treatments (super chlorinate). As a rule,
any pool water that is unsafe for swimming is unsafe for
the cleaner.
10. Carefully cut the feed hose following the instructions on
page 3.
11. By following these simple guidelines, you can help
protect against injury and prolong the life of your
cleaner.
12. Refer to "Important Warning And Safety Instructions"
on pages ii - iii for additional installation and safety
information.
2
8
1
4

Publicité

Table des Matières
loading

Table des Matières