Pentair BLUEFURY LITE Guide D'installation page 10

Installing and Removing the Sweep Hose
The BLUEFURY LITE Pressure Side Pool Cleaner comes from the
®
factory with a Sweep Hose Cap installed over the Sweep Hose
Connection (see Figure 14). This cap blocks flow through the
sweep hose connection when the sweep hose is not being used.
1. To remove the sweep hose cap, while pushing the sweep hose
cap in towards the cleaner, turn it 1/4 turn counter-clockwise
to unlock. Remove the cap from the sweep hose connection
by pulling is straight off the sweep hose connection.
2. Line up the lock tabs on the inside of the sweep hose fitting
(small round fitting on the end of the sweep hose) to the
locking slots on the cleaner's sweep hose connection. See
Figure 15.
3. Push the sweep hose fitting onto the sweep hose connection
and turn clockwise until it stops (about 1/4 turn). Pull the
sweep hose fitting away from the cleaner to lock it into place.
4. To remove the sweep hose, while pushing the sweep hose
fitting towards the cleaner turn counter-clockwise until it
stops (about 1/4 turn). Pull the sweep hose from the sweep
hose connection and store it in a safe place.
Figure 15
Sweep Hose Fitting
Sweep Hose Connection
371885 (REV 12/2016)
Sweep Hose
Connection
Lock Tab
Locking Slot
Figure 14
Sweep Hose
Sweep Hose Cap
Figure 13
Sweep Hose
Scrubber
10