Adjusting The Intensity; Memory Function; Cleaning And Care Of The Unit And Belt - Beurer EM 38 Mode D'emploi

Note:
For program A, the effect becomes stronger when switching from phase 1 to phase 2 (after approx. 10 min-
utes). If the intensity seems too high, decrease it using the ▼ intensity button [2].
Note:
If you change the program during treatment (for example from A to B), the initial intensity in the new
program increases incrementally to the previously set intensity. This can be stopped by pressing the ▼
intensity button [2] for two seconds or by switching off the unit by pressing the on/off button [1] for two
seconds.
Stopping impulses that are too strong
You can decrease the intensity at any time or switch off the unit by holding the on/off button [1] (approx. 2 sec-
onds).

Adjusting the intensity

Press the ▲ intensity button [2] to increase the intensity incrementally or press the ▼ intensity button [2] to lower
the intensity. You can adjust the intensity in 20 Increments. Depending on the intensity level, you may feel a
prickling at first that can escalate to a muscle contraction. Select a setting that is within your comfort level.
Preventing unwanted pulse changes
To prevent an accidental increase in intensity during a treatment session, activate the keylock by pressing the
program selection button P [3] for approx. 2 seconds. The unit beeps and the "
display [5].
To cancel the keylock, press and hold the P [3] button for approx. 2 seconds.
Reacting to unpleasant sensations
If you feel a stinging or itching sensation, switch off the unit and proceed as follows:
• Check whether the electrodes are working properly.
• Check whether the round cover is still present over the electrode connections.
• Take off the belt and moisten it completely once again.
• When refitting the belt, ensure good skin contact and good moistening.
Inserting a pause
If you want to take a break or pause a program, press the Pause button [1] briefly. The unit beeps and the "II"
pause symbol flashes in the display [5]. You can resume the program by pressing the Pause button [1] again.
Contact detection
If the electrodes have no contact with the body, the intensity is set automatically to zero. This prevents unwanted
stimulation. The intensity cannot be increased without contact with the body.

Memory function

The unit stores the most recently configured program.
After a battery change, the unit starts with the first program again.

9. Cleaning and care of the unit and belt

Cleaning the unit
• Remove the batteries from the unit before each cleaning.
• Clean the unit with a soft cloth moistened slightly with water after use. If the dirt is heavier, you can also mois-
ten the cloth with a mild soap solution.
• Ensure that no water penetrates the device.
• Do not use any chemical cleaners or abrasives for cleaning.
NOTICE:
• The belt and control unit are not suitable for machine washing.
Cleaning the belt
Once you have removed the control unit from the belt, clean the belt using a soft cloth and a mild soap solution
or liquid detergent. Do not use bleach.
9
" symbol appears in the