Stihl FS 40 Notice D'emploi page 15

STIHL AutoCut C 5-2
8
2
9
Slip the mowing head (2) on to the
N
shaft – as AutoCut 5-2.
Turn the spool (9) clockwise until
N
the two arrow heads line up –
secure the spool in this position.
Insert the cap (8) in the spool, press
N
it down as far as stop and turn it
clockwise at the same time.
Turn the cap until you feel
N
resistance and then tighten it down
firmly by hand.
FS 40, FS 40 C, FS 50, FS 50 C
STIHL PolyCut 6-3
10
11
5
Fit the thrust plate on the shaft.
N
Insert the nut (10) in the mowing
N
head.
Screw the mowing head (11)
N
clockwise on to the shaft (5) as far
as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Remove the mowing head.
STIHL AutoCut
Hold the mowing head steady.
N
Unscrew the cap counterclockwise.
N
STIHL PolyCut
Block the shaft.
N
Unscrew the mowing head
N
counterclockwise.
English
13