Stihl FS 40 Notice D'emploi page 14

English
1
Fit the thrust plate
N
Turn the mowing head
N
anticlockwise on the shaft (1) as far
as it will go
Retain the shaft
N
Tighten the mowing head
N
NOTICE
Remove the tool that was used to block
the shaft.
Removing the Mowing Head
Retain the shaft
N
Turn the mowing head clockwise
N
12
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
STIHL AutoCut 5-2
4
2
1
3
Fit the spring (1) in the mowing
N
head (2).
Wind the mowing line (3) on to the
N
spool (4).
Thread the nylon line through the
N
sleeves and fit the spool in the head.
The individual steps are described in the
instruction sheet supplied.
6
3
Slip the mowing head (2) over the
N
shaft (5) and engage hex recess (7)
on the external hexagon (6).
Fit the cap (8) on the mowing head
N
– screw it clockwise on to the shaft
as far as stop and tighten it down
firmly.
FS 40, FS 40 C, FS 50, FS 50 C
8
2
7
5