Settings And Adjustments - Life & Mobility MyPlus Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Settings and adjustments

The wheelchair has a wide range of settings and
adjustment options with which the chair can
be adjusted to match your own requirements.
Life & Mobility recommends that you consult your
dealer with regard to the settings. You can easily
make adjustments yourself.
Adjusting the ride characteristics
The ride characteristics of the wheelchair are
adjustable. The rear wheels can be located in three
different positions by moving the axle bearing.
1. Place the axle bearing in one of the three axle
holes.
2. Replace and tighten the M16 nut.
Removing and replacing the QR rear wheels
Note:
n The brake must be disengaged to remove or
replace the wheel.
1. Press the release button in the middle of the
hub (A).
2. Keep the pin pressed and remove the wheel.
3. Lay the wheel down axle-side up, so that the
axle does not become dirty or damaged.
4. Replace the wheel in the axle hole (B). You will
hear a click when the wheel is properly fitted.
5. Ensure that the wheel is correctly attached be-
fore you use the wheelchair again.
Backrest angle adjustment
1. Loosen the socket screws (A) in the backrest
hinge points for a couple of turns.
2. Adjust the backrest angle.
3. Then tighten the socket screws again.
Note:
Using the measurement lines, check whether
the left and right push-handles are at the same
angle.
EN12
EN12
Ride characteristics
B
A
Fitting rear wheel
Backrest angle
Backrest angle adjustment for seat depth
A
The seat depth can be adjusted even more precisely by
moving the back tubes by 4 cm.
1. Remove the seat.
2. Loosen the 2 socket screws (A) on each side for
3. Slide the plate forwards or backwards using the
4. Determine the exact measurement by using the
5. Adjust the ride characteristics, if necessary.
6. Re-tighten the socket screws (A).
Removing and replacing the sides
The sides are easy to remove.
1. Place you hand in the middle of the armrest.
2. Lift out the entire side.
3. Put the side in the holders.
4. Release the armrest.
Note:
Sides
n Ensure that the sides are fitted into the holders and
Removing the legrests
The legrests can be easily lifted from the frame by
holding them above where they are fitted and lifting
them out.
Note:
n Ensure that the footrests have been folded away
Legrests
Settings and adjustments
several turns. We recommend you use the socket
wrench M5 for this, as pictured.
push-handles until the desired seat depth.
measurement lines on both sides of the side frame.
These are indicated with stickers.
Note: ensure that left and right are placed at equal
depths.
not next to them. This can damage the sides and
the wheels.
before you get out of the wheelchair. Never stand
on the footrests. If you do, there is a chance that the
wheelchair will tip over.
EN13
EN13

Publicité

Table des Matières
loading

Table des Matières