Settings & Adjustments - Life & Mobility CUMULIX KELVIN Mode D'emploi

Inspired by life
Safety instructions
Attention:
• When going down a slope, always keep your
speed under control. If necessary, brake the
wheelchair using the brake levers.
Miscellaneous
Warning:
• Keep the wheelchair away from naked flames.
• Do not leave the wheelchair in direct sunlight:
the upholstery may get too hot, which can
burn the skin or make it hypersensitive.
Be careful:
• Do not allow the wheelchair to come in
contact with seawater as seawater is corrosive
and will rust the wheelchair.
• Do not allow the wheelchair to come in
contact with sand, as it may penetrate into
the moving parts of the wheelchair, causing
unnecessarily fast wear and tear.
• Never use abrasive or aggressive cleaning
products or solvents such as thinner, benzene,
etc., to clean the wheelchair.
• Tightening the adjustment screw too far can
damage the wheelchair.
EN12
A
Adjusting the seat width
B
Adjusting the backrest angle
C
Adjusting the seat angle
Settings & adjustments
Life & Mobility recommends that you consult
your dealer with regard to the settings. You
can easily make adjustments yourself.
Use the following tightening guidelines:
M5 socket screws = 6 Nm
M6 socket screws = 10 Nm
M8 socket screws = 25 Nm
M10 socket screws = 50 Nm
Frame
Seat width
It is possible to fit the armrests, further in or out.
This adjustment can be made separately on the
left and on the right using the screws (A).
Backrest angle (one-time adjustment)
1. Loosen the socket screws (B) in the
backrest hinge points.
2. Set the backrest to the required angle.
3. Retighten the socket screws.
Seat angle
The seat angle can be adjusted using the 2
gas springs and the operating lever (C) near
the push-handle.
1. Press the operating levers to disengage
the gas springs.
2. Adjust the seat angle as required.
3. Release the operating levers.
Seat angle range
The seat angle range is 30°. It can be adjusted
from 10° to 40°.
EN13