Dirt Devil NAVIGATOR M608-0 Mode D'emploi page 43

3 Prior to first use
3.3 Connecting the docking station
8
3.4 Charging the battery pack for the first time
WARNING:
Danger of injury! Only use the AC adapter
and docking station supplied with the appli-
ance to charge this equipment.
9
1
10
1. Ensure, that the docking station is being
positioned correctly (Fig. 5).
2. Plug the connector of the AC adapter ca-
ble into the socket on the side of the dock-
ing station (Fig. 8).
3. Connect the AC adapter plug to the mains
socket.
NOTE:
Before operating your robot for the first
time, charge it. This will help to retain the
battery life.
1. Ensure that the docking station is correctly
positioned and connected,
"Connecting the docking station".
2. Activate battery pack charging by switch-
ing the toggle switch underneath the robot
to "on" (Fig. 9, "I" position).
NOTE:
Battery pack can only be charged if toggle
switch is put into "I" position.
3. Place your robot manually onto the dock-
ing station (Fig. 10).
4. Watch out that the charging pins of the
docking station and the charging pins on
the bottom of the robot make contact 1
(Fig. 10/1).
- Red LED is lit and blue LED is flashing.
- A short beep occurs.
- If not, it is not correctly positioned.
In that case, try again.
Chapter 3.3,
43