LENCO LS-50 Mode D'emploi page 17

which Audacity was not able to parse. Just zoom in and select the noise with the Selection Tool, and
then choose Delete from the Edit Menu.
Edit ID3 Tags... - Opens a dialog allowing you to edit the ID3 tags associated with a project, for
MP3 exporting.
Quick Mix - This command mixes all of the selected tracks together. If you are mixing stereo tracks,
or mixing tracks that are marked as Left or Right channel, the result will be a stereo track (two
channels), otherwise the result will be mono. Your tracks are implicitly mixed whenever you hit
the Play button and whenever you export. This command offers a way to do it permanently and
save the results to disk, saving on playback resources.
Note that if you try to mix two very loud tracks together, you may get clipping (it will sound like
pops, clicks, and noise). To avoid this, drag the gain slider on the tracks down to reduce their
volume before mixing.
New Audio Track - This creates a new empty Audio Track. This command is rarely needed, since
importing, recording, and mixing automatically create new tracks as needed. But you can use this
to cut or copy data from an existing track and paste it into a blank track. If that track was at a non-
default rate then you may need to use Set Rate from the Track Pop-Down menu to set the correct
sample rate.
New Stereo Track - same as above, but creates a stereo track. You can also create a stereo track
by joining two tracks using the track pop-down menu.
New Label Track - This creates a new Label Track, which can be very useful for textual annotation.
New Time Track - This creates a new Time Track, which is used to vary the speed of playback over
time.
Remove Tracks - This command removes the selected track or tracks from the project. Even if only part
of a track is selected, the entire track is removed. You can also delete a track by clicking the X in its
upper-left corner. To cut out only part of the audio in a track, use Delete or Silence.
Align Tracks... - All the Align functions work on whole tracks or groups of tracks, not on selections,
even if they span across multiple tracks. They all operate by time-shifting tracks (moving them left
or right), making it easier to synchronize tracks or get rid of silence at the beginning. The cursor
or selection stays in the same place unless you use "Align and move cursor..." below:
Align and move cursor... - same as the functions above, except that the cursor or selection is
moved along with the tracks. That allows you to shift the tracks without losing your relative place.
Add Label at Selection - This menu item lets you create a new label at the current selection. You
can title the label by typing with the keyboard and then hitting "Enter" when you're done.
17