Select Cycle; Pull Control Dial Out To Start - Amana 2201045 Guide D'utilisation Et D'entretien

Using the Controls
STEP 5

Select Cycle

To select a cycle, push the control dial IN and turn until
the pointer is at the soil level needed for the wash load.
Quick Wash
(select models)
This cycle is designed to refresh
clothing. QUICK WASH should only
be used for small loads with little to
no soil and minimal water level. Use
no more than a teaspoon of
detergent.
Ultra Handwash
(select models)
Intermittent slowest agitation and
soak to gently wash the most
delicate items.
Handwash
Intermittent slow agitation and soak
for delicate fabrics needing slow
spin speed because of clothing
construction.
STEP 6

Pull Control Dial Out to Start

You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Regular Cycle
Regular Cycle is used for normal,
sturdy fabrics and uses the
following settings:
HEAVY: approximately 15 minutes
of wash time.
NORMAL: approximately 12
minutes of wash time.
LIGHT: approximately 9 minutes of
wash time.
No Iron Fabrics
This cycle is designed for sturdy
fabrics needing a slower spin speed
to reduce wrinkling, such as dress
shirts and dress pants.
NORMAL: approximately 12
minutes of wash time.
LIGHT: approximately 9 minutes of
wash time.
See Laundering Tips for proper washing procedures,
stain removal, and special laundering situations.
6