SOLIS ECO SILENT 7584 Mode D'emploi page 41

T HE F UNC TI ON BU TTON S
O N T HE REMOTE CO NTROL
• Caution: The appliance can only be
operated via remote control if the
remote control has been connected
to the appliance and activated as
described in the section "Preparing the
remote control for use".
•
You can have the current room temper-
GB
ature displayed by once briefly touching
one of the buttons on the remote con-
trol.
A On/Off switch
If the fan is connected to the power, it can be switched on and off with this
button, which can be found on both the remote control and the motor casing.
Briefly touch the On/Off switch on the remote control twice. The current room
temperature and the current setting are displayed, then the rotor blade starts
up.
Touch the button again to switch the appliance off.
B Speed button
With the speed button, you can set one out of eight different ventilation speeds.
The corresponding number lights up in the display. Touching the button one
time increases the speed by one level. After the highest level 8 has been sur-
passed, the display switches back to 1, the lowest level.
C Oscillation button
With the oscillation button, you can choose one out of four different oscillation
angles. Each touch of the button switches the setting to the next angle.
The possible settings are: 30°, 60°, 90° and 120°. The corresponding number
lights up in the right hand side of the display.
After surpassing the highest level 120°, the appliance switches the oscillation
back off if the button is touched again.
80
D Timer button
With the timer button, you can set an operation time between 1 and a maximum
of 12 hours at 1-hour-intervals. After the hours have elapsed, the appliance
switches off automatically. Each touch of the button increases the time setting
by one hour. If the button is touched again after the highest setting, 12, the
timer function switches back off.
If the timer is activated, the timer symbol lights up in the right hand side of the
display.
Caution: Even if you have activated the timer, you can switch the appliance off
beforehand with the On/Off button. The timer setting is not saved if the appli-
ance is switched back on after that.
E Program button
You can use the program button to choose from 3 different programs:
1. Automatic program: The automatic program measures the current room tem-
perature and adjusts the ventilation speed according to this temperature. The
symbol lights up in the display.
Depending on the room temperature, the rotor blade rotates at 2 different
ventilation speeds, switching between them in 15-second intervals.
Under 25 °C, the two speed settings are the lowest ones, 1 and 2. Between 25 °C
and 28 °C the appliance operates at the speed levels 3 and 4, between 29 °C
and 34 °C, it operates at the speed levels 5 and 6 and above 34 °C, it operates
at the speed levels 7 and 8.
The automatic program is not saved. If the appliance is switched off and back
on again, it is reset to the standard program.
2. Sleep program (Touch the button again): In the sleep program, the speed
gradually increases until it reaches the base speed that you have set before
decreasing again. The symbol lights up in the display.
The sleep program is not saved. If the appliance is switched off and back on
again, it is reset to the standard program.
3. Standard program (Touch the
ventilation speed is constantly held. No symbol is lit up in the display.
button again): In the standard program, the
GB
81