Cleaning metal grease filters
The metal grease filters can be cleaned in hot
detergent solution or washed in the dishwasher.
• Remove grease filters.
They should be cleaned every 2 months use, or
more frequently if use is particularly heavy.
• Open the visor by pulling it.
• Remove the filter, pushing the lever towards the
back of the unit and at the same time pulling
downward.
• Wash the filter without bending it, leave it to dry
thoroughly before replacing (if the surface of
• Screw the Frame into place
the filter changes color over time, this will have
absolutely no effect on its efficiency).
• Replace, taking care to ensure that the handle
faces forward.
• Cleaning in dishwasher may dull the finish of
the metal grease filter.
• Close the visor.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and must be replaced
approximately every 4 months of operation, or
more frequently with heavy usage.
• Open the visor by pulling it.
• Remove the Filter, pushing it towards the back of
the unit and at the same time pulling downward.
EN
• Remove the saturated Activated Charcoal Filters,
as indicated (A).
• Fit the new Filters, as indicated (B).
• Replace, taking care to ensure that the handle
faces forwards.
• Close the visor.
Lighting unit
• Turn off electrical supply before replacing bulbs,
and make sure bulbs are cool to touch before
proceeding.
• Remove the lamp at the base and turn slightly
to the left and the pull out from the connector
and turn slightly to the left.
• Replace the lamp with a new one of the same
type, making sure that you insert the two pins
properly into the housings on the lamp holder.
• Once the bulb pins are in place turn slightly to
the right to secure.
12
fixing pin lever.
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
A
B
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993