Cleaning Metal Grease Filters; Replacing Activated Charcoal Filter - Bertazzoni KMC30X Instructions D'installation

Cleaning metal grease filters

These can be washed in the dishwasher, and need
to be cleaned whenever the S1 Led comes on or at
least once every 2 months use, or more frequently if
use is particularly intensive.
Resetting the alarm signal
• Turn the Lights and the Suction Motor off.
• Press T3 and hold for at least 3 seconds, until LED
flashes three times in confirmation.
Cleaning
• Remove the filter, pushing the lever towards the back
of the unit and at the same time pulling downward.
• Wash the filter without bending it, leave it to dry
thoroughly before replacing (if the surface of the filter
changes color over time, this will have absolutely
no effect on its efficiency).
• Replace, taking care to ensure that the handle
faces forward.
• No water can be present in filters before installing
back in hood.

Replacing Activated Charcoal Filter

This cannot be washed or regenerated, and must
be changed when led S1 starts to flash, or at least
once every 4 months. The Alarm signal, if it has been
activated, only appears when the Suction motor is
turned on.
Resetting the alarm signal
• Turn the Lights and the Suction Motor off.
• Press T3 and hold for at least 3 seconds, until LED
flashes three times in confirmation.
Cleaning
• Remove the charcoal filter by rotating it clockwise
(backwards) until it unlocks from the motor housing
and pull off sideways.
• To re-insert each charcoal filter, place up against
the side of the blower and push it inward. Then
turn the charcoal filter clockwise (forward) until it
fits into place.
• CAUTION: When used in recirculation mode,
to Reduce the Risk of Fire and Shock use only
conversion Charcoal Accessory.
LED LIGHTING UNIT
• LED lights must be replaced by Bertazzoni factory
authorized service.
31